|
 |
 |
 |
| 1.
Healing Check Lines |
| Denseo Genie can be used on any
popular veneering ceramics for precious
and non-precious alloy frameworks. |
|
| 2. Grinding the
Crown |
| Slightly roughen the entire surface
of the crown to be healed. Clean the
surface with steam only, wihout
additive. |
|
|
3.
Mix
Ceramic Particles |
|
***IMPORTANT***
Shake
well before each use |
|
 |
|
 |
 |
 |
| 4. Applying Denseo
Genie |
5.
Firing the Crown |
6.
No more Check Lines |
| Allow to dry briefly and apply a
thin and even layer of Denseo Genie to
the entire crown, just as you would
apply a standard glaze. |
|
| Fire the
crown using the "healing cycle"
program parameters (See below),
taking the specific properties
of the framework material into account. |
|
| Do not perform a
glaze firing after applying Denseo Genie! Polish the surface if necessary.
Do not return any excess material to the
original container. |
|
|
|
|
 |
Denseo® Genie: Healing Cycle |
|
| |
Denseo Genie 730 |
Denseo Genie 830/Zirconia |
| Pre-heating/start temperature |
450°C |
500°C |
| Pre-drying/pre-heating time |
4min |
4min |
| Temperature increase |
60°C/min |
50°C/min |
| Final Temperature |
730°C |
830°C |
| Holding time |
45 sec |
1 min 15
Sec |
| Vacuum start |
450°C |
500°C |
| Vacuum stop |
730°C |
830°C |
|
Note: Adjustments may be required due to differences
in furnace performance. Increase the temperature
slightly for larger-span bridges.
Storage: Store in a cool and dry place
(15-25°C, RH 35-65%). Shelf life: See label. |
|
|
Need More Help?
